- Flathead screwdriver
- Socket set
- Wrench
Instructions:
1. Disconnect the negative battery terminal.
2. Remove the passenger side front wheel and the wheel well cover.
3. Locate the crankshaft sensor. It is located on the front of the engine block, just below the cylinder head.
4. Disconnect the electrical connector from the sensor.
5. Use the flathead screwdriver to pry up the retaining clip.
6. Use the wrench to loosen the bolt holding down the sensor.
7. Remove the old sensor and replace it with the new sensor.
8. Tighten the bolt and reconnect the electrical connector.
9. Replace the wheel well cover and the wheel.
10. Reconnect the negative battery terminal.
Tips:
- Make sure that the new sensor is properly seated before tightening the bolt.
- If the sensor is difficult to remove, you can use a penetrating oil to loosen it up.
