Auto >> AutoSPT >  >> Engine

How do you remove Mazda mx 3 headlight unit?

To remove the Mazda MX-3 headlight unit, you will need the following tools:

* Phillips head screwdriver

* Flat head screwdriver

* 10mm socket wrench

* Ratchet

* Extension bar

Instructions:

1. Open the hood of your Mazda MX-3.

2. Locate the two Phillips head screws on the top of the headlight unit. Remove these screws.

3. Locate the two 10mm bolts on the bottom of the headlight unit. Remove these bolts.

4. Use the flat head screwdriver to pry the headlight unit out of the car.

5. Disconnect the electrical connector from the back of the headlight unit.

6. Remove the headlight unit from the car.

To reinstall the headlight unit, simply follow these steps in reverse order.

Auto Repair
How do you Replace the ignition switch on a 1967 ford mustang? How do you remove the drivers side door panel on a 2000 Dodge Avenger so that electric lock-window assembly can be re-resured?
Car Care
Why Is My Hyundai Pulling to the Left or Right Side? Can you register and insure a car if are not on the loan? How Do You Clean Vinyl Wraps?
Engine
What causes a ticking noise in the engine of 2002 Trailblazer at idle? Why has your Mercedes Sprinter Van dropped at the front?
Electric Car
Does a 1998 Chrysler sebring key have chip? What kind of oil should you put in your 89 Chevrolet truck? How do you change the heater-AC blower motor on a 1991 Chevy S-10 and where is it located?
Autopilot
1995 Nissan altima speedometer gauge does not work? How do you jump start a Mercedes m class?
Car Photos
Where can you find a rear brake diagram for 1983 Chevy Camaro? How do you tell what size motor your 1976 Corvette had in it? What does the red car on dashboard signify?