1. Disconnect the fuel line connector from the fuel filter.
2. Place the end of the fuel line into a container that can hold fuel.
3. Turn the ignition key to the "On" position for 10 seconds, then turn it off.
4. Repeat step 3 until fuel flows out of the fuel line and into the container.
5. Once fuel is flowing out of the fuel line, reconnect the fuel line connector to the fuel filter.
6. Turn the ignition key to the "Start" position until the engine starts.
Note: If the engine does not start after priming the fuel system, you may need to bleed the air from the injectors. To do this, loosen the injector lines at the injectors, one at a time, until fuel flows out. Then, tighten the injector lines and start the engine.
