* Philips screwdriver
* Flathead screwdriver
* Socket wrench set
* 10mm socket
* 8mm socket
* Extension for socket wrench
* Pry tool
* Flashlight
Instructions
1. Open the hood of your car.
2. Locate the headlight assembly you wish to replace.
3. Use a Philips screwdriver to remove the screws that secure the headlight assembly in place.
4. Use a flathead screwdriver to pry up on the plastic tabs holding the headlight assembly in place.
5. Disconnect the electrical connector(s) from the back of the headlight assembly.
6. Use the socket wrench set and 10mm socket to remove the nuts holding the headlight assembly to the car frame.
7. Use the socket wrench set and 8mm socket to remove the bolts holding the headlight assembly to the car frame.
8. Remove the headlight assembly from the vehicle.
9. To install the new headlight assembly, reverse the removal procedure.
Additional notes:
* Be careful not to drop the headlight assembly. It is made of glass and could break if dropped.
* When disconnecting the electrical connector(s), be careful not to damage the wires.
* When installing the headlight bolts and nuts, do not overtighten them, as this could damage the headlight assembly.
