_Note: This guide involves working on the fuel system. Please take proper precautions, such as working in a well-ventilated area and avoiding any sources of ignition._
1. Park your car in a well-ventilated area and turn off the engine. Apply the parking brake.
2. Relieve the pressure in the fuel line by pressing the Schrader valve on the fuel rail using a suitable tool.
3. Locate the fuel filter. It's usually situated below the rear passenger door, between the fuel line and the engine.
4. Disconnect the fuel lines attached to the filter. Do this by pressing down on the release button on the fuel line connector and pull it off the filter. Be cautious as there may be some residual fuel that could spill.
5. Remove the mounting bracket that secures the fuel filter. There are usually two bolts holding it in place.
6. Pull the old filter out of the mounting bracket.
7. Clean the mounting bracket and its surroundings.
8. Take the new filter and insert it into the mounting bracket.
9. Secure the filter using the mounting bolts.
10. Reinstall the fuel lines. Press the release button on the fuel line connector and push it onto the filter until it clicks and locks into place.
11. Repeat these steps for any additional fuel filters that your vehicle may have.
12. Start the engine and check for fuel leaks. If there are any, tighten the fuel line connectors or replace the filter's O-rings.
