Auto >> AutoSPT >  >> Engine

How do you get a crank sensor out of 1990 Buick engine if part it has broken off?

1. Locate the crank sensor. The crank sensor is located on the front of the engine, near the bottom. It is a small, cylindrical sensor with a wire connector.

2. Disconnect the wire connector. Disconnect the wire connector from the crank sensor.

3. Remove the mounting bolt. Use a wrench to remove the mounting bolt that holds the crank sensor in place.

4. Remove the crank sensor. Once the mounting bolt is removed, you can remove the crank sensor from the engine.

5. If part of the crank sensor has broken off, you will need to remove the broken piece from the engine. Use a pair of pliers or tweezers to remove the broken piece.

6. Install a new crank sensor. Insert the new crank sensor into the engine and secure it with the mounting bolt.

7. Reconnect the wire connector. Reconnect the wire connector to the crank sensor.

Auto Repair
How do you replace the drive belt on a 1991 Chevy Corvette? How effective are Helmets estimated to be in preventing fatal injuries motorcyclists?
Car Care
Increase Vehicle Performance – Shop Foreign Affairs Glove Compartment (Glove Box) Must-Haves More Than Half the Country Is Taking Crazy Chances On Their Bicycles
Engine
What is the horsepower for a stock 6-cylinder automatic 1995 camaro? How do engine retarder brakes work?
Electric Car
Where are the location fuel pump driver module on Ford Taurus? How fast does a 2013 Honda pcx150d go? How do you install rear shocks on a 73 camaro?
Autopilot
Is the Honda 750 ace motorcycle a good touring motorcycle? National Robotics Week Highlight – Safer Roads with Connected Automation
Car Photos
What headlight bulbs does a 2007 Toyota Camry take? What happens when your knee gets crushed by a car? What are the panels called between tail light and quarter panel on a 1987 Cadillac Brougham?