Here are the general steps involved in removing a manual transmission from a 1993 Ford Probe SE and installing a 1996 GT V6 short throw shifter:
1. Safety First:
- Disconnect the negative terminal from the battery to avoid electrical accidents during the process.
2. Raise the Vehicle:
- Safely raise the vehicle off the ground using a car jack and jack stands.
3. Remove the Driveshaft:
- Locate and disconnect the driveshaft from the transmission and differential flange. (This may require unbolting the driveshaft from the differential.)
4. Remove the Starter:
- Disconnect the starter wires and then remove the starter from the vehicle.
5. Remove the Transmission Crossmember:
- Locate and remove the transmission crossmember that supports the transmission underneath the vehicle.
6. Unbolt the Transmission:
- Unbolt the transmission from the engine block. There may be several bolts around the circumference.
7. Remove the Shift Lever:
- Remove the shift lever from the transmission by unbolting it or loosening the retaining mechanism.
8. Remove Clutch Components (Manual Transmission):
- If you're removing the manual transmission, you'll need to detach components like the clutch cable and slave cylinder.
9. Pull Out the Transmission:
- Position a transmission jack underneath the transmission to support it. While supporting its weight, carefully slide the transmission out of the vehicle.
10. Check Compatibility (96 GT Shifter):
- Verify that the 1996 GT short throw shifter assembly is compatible with your vehicle's model and transmission.
11. Position the New Transmission:
- Carefully position the 96 GT transmission in its place. Ensure that the alignment pins on the transmission and engine block match up.
12. Bolt in the Transmission:
- Reinstall the bolts and secure the transmission to the engine block.
13. Reattach Components:
- If installing the 96 GT transmission, reconnect any components that were removed, such as the shift lever linkage and clutch components (if applicable).
14. Replace Crossmember:
- Reinstall the transmission crossmember and secure it in place.
15. Reconnect Driveshaft:
- Reattach the driveshaft to the transmission and differential.
16. Reattach Starter:
- Reinstall the starter and connect its wiring.
17. Reconnect Battery Terminal:
- Reconnect the negative terminal to the battery.
18. Test the Transmission:
- Start the vehicle. Test the transmission and ensure that all gears shift smoothly without any issues.
Remember, this process requires expert mechanical knowledge and skills. It's essential to consult a professional or do proper research before attempting such a complex procedure to avoid any potential complications.
