- Make sure that your Z-wave lamp module is rated as a slave device and is compatible with the 301Mhz frequency that the lear car2u remote operates on.
Step 2: Reset your device
- If this is your first time connecting your lamp to the Lear remote press and hold the pairing button on your lamp fixture until the LED turns on. Wait for the LED to turn off, and press and hold the pairing button again until the LED slowly blinks.
Step 3: Place your lamp and remote in pairing mode.
To pair your lamp module to the Lear car2u remote, place both the lamp and the remote into pairing mode. This process may vary slightly depending on your specific lamp model, but here's a general guide:
Z-Wave lamp: Press and hold the pairing button on your lamp fixture until the LED starts blinking rapidly.
Lear car2u remote: Slide the switch at the bottom of the remote to pair the first button, and press the green learn button. This will activate the learning mode on the remote.
Step 4: Pair your devices.
- Within a few seconds, press the desired key on the Lear remote that you wish to use to control your lamp. If the pairing is successful, the key's LED will flash slowly.
Step 5: Test the connection.
Press the paired key on the Lear car2u remote to check if your Z-Wave lamp module responds correctly. The lamp should turn on when you press the button, and turn off when you release it.
Step 6: Finish Pairing.
- Once all your desired keys on the Lear remote have been paired, close the remote's slide switch to finalize the pairing process.
