Philips head screwdriver
Flat head screwdriver
New power window switch
Instructions:
1. Park your car in a safe location and turn off the engine.
2. Open the driver's door.
3. Locate the power window switch assembly. It is located on the driver's door, just below the armrest.
4. Use a Philips head screwdriver to remove the two screws that hold the power window switch assembly in place.
5. Use a flat head screwdriver to pry the power window switch assembly out of the door panel.
6. Disconnect the electrical connector from the back of the power window switch assembly.
7. Connect the electrical connector to the new power window switch assembly.
8. Insert the new power window switch assembly into the door panel.
9. Use the screws that you removed in step 4 to secure the power window switch assembly in place.
10. Test the power window switch assembly to make sure that it works properly.
Tips:
If you are having trouble removing the power window switch assembly, you may need to use a heat gun to loosen the adhesive that holds it in place.
Be careful not to damage the door panel when you are removing the power window switch assembly.
Always follow the safety instructions that are provided in your vehicle's owner's manual before performing any repairs.
