1. Park your car on a level surface and engage the parking brake. Turn off the engine and allow it to cool down.
2. Raise your car with a jack or ramps. Ensure the jack or ramps are secure before proceeding.
3. Locate the oil drain plug. It is typically located on the bottom of the oil pan, near the front of the engine.
4. Place an oil drain pan with at least a 2 quart capacity under the oil drain plug.
5. Use a wrench to loosen the oil drain plug. Do this carefully, as hot oil may still be inside the engine.
6. Allow the oil to drain out completely. This may take several minutes.
7. Replace the oil drain plug and tighten it securely.
8. Locate the oil filter. It is usually found on the top of the engine, near the front.
9. Use an oil filter wrench or pliers to loosen the oil filter. Be careful not to spill any oil.
10. Remove the old oil filter.
11. Apply a thin coat of new engine oil to the gasket of the new oil filter.
12. Screw on the new oil filter until it is snug. Do not overtighten the oil filter.
13. Lower your car to the ground.
14. Open the hood of your car.
15. Locate the oil fill cap. It is typically located on the top of the engine, near the front.
16. Remove the oil fill cap.
17. Use a funnel to add new engine oil to the engine. The exact oil amount will vary depending on your vehicle.
18. Replace the oil fill cap and close the hood of your car.
19. Start the engine and let it run for a few minutes. This will circulate the new engine oil throughout the system.
20. Check the oil level using the dipstick. The oil level should be between the "full" and "add" marks on the dipstick.
Note:
- It is essential to use the correct type of engine oil for your vehicle. Check your owner's manual for the recommended oil type.
- If you are uncomfortable changing the oil yourself, you can have it changed at a qualified auto service shop.
