- A Phillips head screwdriver
- A flat head screwdriver
- A pair of pliers
- A wire stripper
Instructions:
1. Turn off the engine and remove the keys from the ignition.
2. Open the hood of your Jeep Wrangler and disconnect the negative terminal of your battery.
3. Remove the four screws that hold the radio bezel in place.
4. Pry the radio bezel off of the dashboard using the flat head screwdriver.
5. Disconnect the wiring harness from the back of the radio.
6. Remove the four screws that hold the radio in place.
7. Pull the radio out of the dash.
8. Disconnect the antenna wire from the back of the radio.
9. Remove the two screws that hold the radio cage in place.
10. Remove the radio cage from the dash.
11. Reconnect the battery terminal and test the radio.
