Tools Needed:
- Flat-head screwdriver
- Phillips-head screwdriver
- New rearview mirror
- Rag
Instructions:
1. Detach the Cover Plate:
- Use a flat-head screwdriver to gently pry off the cover plate located at the base of the rearview mirror.
2. Disconnect the Electrical Connectors:
- Once the cover plate is removed, you should see the wiring and electrical connectors for the mirror.
- Gently disconnect these connectors by pressing the release tabs and pulling them out.
3. Remove the Mirror Glass:
- Carefully press the tabs at the top and bottom of the mirror glass to release it.
- Lift the mirror glass out of the housing.
4. Remove the Existing Mirror Assembly:
- Use a Phillips-head screwdriver to remove the screws holding the mirror assembly in place.
- Gently pull the mirror assembly straight towards you to remove it from the windshield.
5. Disconnect the Windshield Mount Bracket:
- Unclip the electrical connector on the windshield mount bracket.
- Remove the windshield mount bracket by sliding it off the windshield.
6. Remove and Transfer any Electronics:
- If your old mirror had any electronics, remove these from the back of the mirror head and transfer them to the new one.
7. Install the New Mirror Assembly:
- Slide the new mirror assembly into the windshield mount bracket.
- Tighten the screws to secure the mirror assembly in place.
8. Install the Windshield Mount:
- Slide the windshield mount bracket back onto the windshield and reconnect the electrical connector.
9. Reattach the Electrical Connectors:
- Plug in the electrical connectors you disconnected earlier, making sure they are secured.
10. Install the Mirror Glass:
- Gently snap the mirror glass back into place, ensuring that both top and bottom tabs are securely engaged.
11. Reinstall the Cover Plate:
- Snap the cover plate back into place over the electrical connections at the base of the mirror.
12. Test the Mirror:
- Once everything is installed, adjust the mirror to your desired position.
- Test the mirror controls, including power adjustments and tilt, to ensure they are functioning properly.
By following these steps, you should have successfully replaced the rearview mirror on your 2010 Mercedes-Benz C300 W204.
