- Toyota Sequoia front bumper
- 10mm socket wrench
- 12mm socket wrench
- Phillips head screwdriver
- Flat head screwdriver
- Zip ties
- Bungee cords
- Helper (optional)
Instructions:
1. Park your Sequoia on a level surface and engage the parking brake.
2. Locate the ten 10mm bolts that secure the front bumper to the vehicle. There are four bolts on the top of the bumper, two on each side, and six bolts along the bottom of the bumper.
3. Use a 10mm socket wrench to remove the ten bolts.
4. Locate the two Phillips head screws that secure the bumper to the fenders. There is one screw on each side, located near the top of the bumper.
5. Use a Phillips head screwdriver to remove the two screws.
6. Locate the two flat head screws that secure the bumper to the radiator support. There is one screw on each side, located near the bottom of the bumper.
7. Use a flat head screwdriver to remove the two screws.
8. Using bungee cords, support the bumper while you work on detaching it from the vehicle.
9. Carefully pull the front bumper away from the vehicle. Be careful not to drop the bumper.
10. Locate the two 12mm bolts that secure the bumper brackets to the vehicle. There is one bolt on each side, located behind the bumper.
11. Use a 12mm socket wrench to remove the two bolts.
12. Detach the bumper brackets from the vehicle. Be careful not to drop the bumper brackets.
13. Set the old bumper aside and place the new bumper in place. Make sure that the new bumper is aligned properly with the vehicle.
14. Insert the two 12mm bolts through the bumper brackets and secure them to the vehicle.
15. Reattach the bumper brackets to the vehicle.
16. Secure the bumper to the fenders with the two Phillips head screws.
17. Secure the bumper to the radiator support with the two flat head screws.
18. Remove the bungee cords.
19. Double check that all bolts and screws are tightened securely.
20. Enjoy your newly installed front bumper!
