Methods to Try (In Order of Preference):
1. Check for a Keypad or Hidden Switch: Some factory alarms had keypads hidden inside the car (often near the steering column or under the dash). Look carefully for a small, usually unlabeled, keypad. Consult your owner's manual (if you have it) for specifics on alarm disablement.
2. Try the Ignition Key: In *some* older vehicles, inserting the key into the ignition and turning it to the "ON" position (without starting the engine) might disarm the alarm. Try this for about 30 seconds.
3. Hood Switch (If Applicable): Some alarms have a hood switch that triggers the alarm if the hood is opened. Check if the hood is properly closed and latched.
4. Battery Disconnect (Last Resort): Disconnecting the negative (-) terminal of the car battery for a few minutes will usually reset the alarm system. However, this will also reset your radio presets and other computer settings. Reconnect the battery and try the ignition.
5. Professional Assistance: If none of the above works, you'll need to contact a locksmith experienced with older vehicle alarm systems or a Chrysler specialist. They have the tools and expertise to bypass or disable the alarm safely.
Important Considerations:
* Safety: Always prioritize your safety. Be mindful of your surroundings and take precautions when working around the vehicle's electrical system.
* Damage: Improperly attempting to disable the alarm could cause further problems.
* Cost: Calling a professional will likely be the most expensive option, but it's also the safest and most reliable.
Without knowing the exact alarm system fitted to your specific 1996 Chrysler Sebring Convertible, these are general suggestions. Finding a service manual specific to your vehicle's year and model *might* offer more detailed information.
