To check the fluid:
1. Warm up the transmission: Run the car until the transmission fluid is warmed up to its normal operating temperature. This is important for an accurate reading. About 10-15 minutes of driving is usually sufficient.
2. Park the car on a level surface: Make sure the car is parked on level ground, and the engine is running.
3. Locate the dipstick: Identify the dipstick (it might have markings indicating "Transmission Fluid").
4. Remove the dipstick: Carefully remove the dipstick, wipe it clean with a lint-free cloth, and reinsert it fully.
5. Remove the dipstick again: Remove the dipstick again and check the fluid level. The dipstick will have markings indicating the "ADD" and "FULL" levels. The fluid level should be somewhere between these markings, ideally closer to "FULL."
6. Add fluid (if necessary): If the fluid level is low, add transmission fluid of the correct type (check your owner's manual for the recommended type). Add a small amount at a time and recheck the level. Never overfill.
Important Notes:
* Consult your owner's manual: Your owner's manual is the definitive source for information on your specific vehicle. It will tell you the exact location of the dipstick, the correct type of transmission fluid to use, and the proper procedure for checking and adding fluid.
* Fluid condition: While checking the level, also check the condition of the fluid. It should be reddish-pink and relatively clear. Dark, burnt-smelling fluid indicates potential problems requiring professional attention.
If you're having trouble locating the dipstick, referring to a repair manual specific to your 1993 Ford Probe or consulting a mechanic is advisable. Improper fluid levels can severely damage the transmission.
