Auto >> AutoSPT >  >> Auto Repair

How do you reset tire pressure sensor 2011 ford ranger?

To reset the tire pressure sensor on a 2011 Ford Ranger, follow these steps:

1. Turn on the ignition without starting the engine.

2. Press and hold the TPMS reset button. This button is located in the lower-left corner of the instrument cluster.

3. Press the TPMS reset button three times within 10 seconds.

4. Release the TPMS reset button.

The TPMS light will flash three times to confirm that the tire pressure sensors have been reset. It takes approximately 20-30 minutes for the system to fully reinitialize and be operational at speeds in excess of 20 miles per hour.

- Note: If the TPMS light does not flash three times, the reset procedure was not performed correctly. Repeat the steps above to reset the tire pressure sensors.

Auto Repair
How often am I supposed to have air duct cleaning service performed in my home? Why Are Toyota Land Cruisers So Expensive?
Car Care
How To Reset Transmission Control Module In Chevy How much money do you save on car insurance when turn 25 years old? Engine Maintenance: Get Those Belts Checked
Engine
Where can you get a 455 olds engine alternator wiring diagram? Where are the fuel injectors on a 1996 Chevy S10 blazer?
Electric Car
How do you change the ignition switch on a 1990 Oldsmobile Cutlass Ciera? Your 2002 Ford Explorer AC is leaking water inside the carpets according to a evaporator coil Any other ideas? What should you check next if already replaced the battery and starter your vehicle still will not start?
Autopilot
How do you calibrate the timing on a 1984 VW rabbit? Day 3 Capability: Reduce Speed for a Merging Vehicle
Car Photos
Where can you find car sprites for pivot? How do you fix the tail lights remaining on after car is shut down and rear window brake light not working a 1994 Toyota Tercel? What is the towing capacity of a 1990 Volvo 240?