- Phillips head screwdriver
- Flathead screwdriver
- Wrench
Instructions:
1. Open the door and remove the two Phillips head screws that are located in the door handle recess.
2. Remove the two screws located at the bottom of the door panel.
3. Locate the plastic cover that is on the side of the door panel and remove it using a flathead screwdriver by prying it off.
4. Remove the screw located behind the plastic cover.
5. Use the flathead screwdriver to pry off the door panel retaining clips that are located around the perimeter of the door panel. There are a total of 10 retaining clips.
6. Once all of the retaining clips have been removed, lift up on the door panel and pull it towards you to remove it.
7. Disconnect the electrical connectors that are attached to the door panel.
8. To access the window regulator, you will need to remove the window glass. To do this, roll the window down halfway, then remove the two bolts that hold the window glass to the regulator.
9. Once the bolts are removed, carefully lift the window glass up and out of the door panel.
10. The window regulator is now visible and can be removed by removing the bolts that hold it in place.
