* 38mm socket
* 10mm socket
* Ratchet and extension
* Flat-head screwdriver
* Utility knife
* Pliers
* New water pump
* Gasket maker
* coolant
Instructions
1. Park your car on a level surface and allow the engine to cool down completely.
2. Disconnect the negative terminal of the battery to prevent electrical shock.
3. Open the hood of your car and locate the water pump, it is positioned on the front of the engine.
4. Use the screwdriver and utility knife to remove the serpentine belt.
5. Use the 38mm socket to remove the water pump pulley bolt and remove the pulley from the shaft.
6. Use the 10mm socket to unbolt the water pump from the engine and discard the old gasket.
7. Apply the gasket maker to the new water pump gasket.
8. Install the new water pump to the engine and tighten the bolts.
9. Attach the water pump pulley back on to the shaft and screw in the bolt.
10. Tighten the serpentine belt on the water pump pulley and reconnect the negative terminal of the battery.
Your water pump is now successfully replaced!
