1. Preparation:
- Park the car on a flat surface and engage the parking brake.
- Gather the necessary tools and materials, including the rubber pads, adhesive promoter, adhesive, a cleaning cloth, and a wrench.
2. Cleaning the Pedal Surface:
- Use a cleaning cloth and mild detergent to thoroughly clean the surface of the brake pedal where the rubber pad will be installed.
- Make sure the surface is free from dirt, grease, and debris.
- Allow the pedal surface to dry completely.
3. Applying Adhesive Promoter:
- Apply a thin layer of adhesive promoter to the surface of the brake pedal where the rubber pad will be installed.
- Follow the instructions on the adhesive promoter packaging regarding application and drying time.
4. Applying Adhesive:
- Apply a thin and even layer of adhesive to the back of the rubber pad.
- Be careful not to apply excessive adhesive, as it may cause the pad to become too thick and affect pedal feel.
5. Positioning and Pressing the Pad:
- Carefully position the rubber pad on the brake pedal, aligning it correctly.
- Press the rubber pad firmly and evenly onto the pedal surface to ensure a secure bond.
- Hold the pad in place for a few seconds to allow the adhesive to set.
6. Curing Time:
- Allow the adhesive to cure according to the manufacturer's instructions. This may vary depending on the type of adhesive used.
- It's important to let the adhesive cure completely before using the brake pedal.
7. Testing the Installation:
- Once the curing time is complete, gently press the brake pedal to check its stability and functionality.
- Make sure the rubber pad is firmly attached and does not move or slip.
By following these steps, you can successfully install rubber pads on the brake pedals of classic cars, providing enhanced grip and safety while preserving the original aesthetics of your classic vehicle.
