* Phillips head screwdriver
* Flathead screwdriver
* 10mm socket wrench
* 12mm socket wrench
Instructions
1. Open the trunk of your Toyota Echo.
2. Remove the two Phillips head screws that are located on the inside of the trunk lid, near the top of the bumper.
3. Use a flathead screwdriver to pry up the plastic trim piece that is located along the bottom of the bumper. There are four clips that hold this trim piece in place.
4. Once the trim piece is removed, you will see four 10mm bolts that are holding the bumper in place. Remove these bolts.
5. Use a 12mm socket wrench to remove the two 12mm bolts that are located on the inside of the wheel wells, near the bottom of the bumper.
6. Once all of the bolts are removed, you can carefully pull the bumper off of the car.
Tips
* Be careful not to damage the paint on your car when you are removing the bumper.
* If you have any questions, please consult with a qualified mechanic.
