Auto >> AutoSPT >  >> Auto Repair

How do you change signal flasher on 2002 buick century?

To change the signal flasher on a 2002 Buick Century, you will need to follow these steps:

1. Locate the flasher relay. It is located in the fuse block under the hood of your car.

2. Remove the old flasher relay by gently pulling it out of its socket.

3. Insert the new flasher relay into the socket.

4. Make sure that the new flasher relay is securely seated in the socket.

5. Close the fuse block cover.

6. Test the new flasher relay by turning on your hazard lights. If the hazard lights flash normally, then the new flasher relay has been installed correctly.

Auto Repair
Is there a special wrench used to remove the oil pressure switch on 1998 Chrysler Town and country Van? How do you change wheel bearings on a Chevy truck?
Car Care
Car Battery FAQs All You Need to Know About Batteries for Electric Cars How Did the Cannonball Run Record Start? (Cannonball History Part 1)
Engine
What side is the number one cylinder at on a 2005 5.3 liters Chevy? How do you remove the engine cover on a 2005 Kia Sedona?
Electric Car
Where can one purchase cars in Cork? Where are the freeze plugs on a 1996 Chevy S-10? Where is the fuel filter located on a 1992 Cadillac DeVille?
Autopilot
Where is the crank sensor on a 2002 intrigue? How do I get weapons and characters on Pivot Stick Figure Animator?
Car Photos
Do you have a picture of the firing order Nissan truck 1989 model D21? What is the picture of firing order for a 1990 Chevy Camaro RS 3.1? What can cause a car to shake after you start it?