* Phillips head screwdriver
* Flathead screwdriver
* Pliers
* 5mm hex key
* New headlight washer nozzle
* Washer fluid
* Rags
Instructions:
1. Turn off the engine and allow the vehicle to cool down.
2. Open the bonnet (hood) of the vehicle.
3. Locate the headlight washer nozzle on the front bumper of the vehicle. It is usually located near the bottom of the headlight.
4. Use the Phillips head screwdriver to remove the screws securing the nozzle in place.
5. Gently pry the nozzle out of its housing using the flathead screwdriver.
6. Disconnect the washer fluid hose from the nozzle by pulling it off.
7. Use the pliers to remove the 5mm hex screw securing the washer fluid reservoir.
8. Remove the washer fluid reservoir from the vehicle.
9. Clean the washer fluid reservoir with water and mild detergent.
10. Reinstall the washer fluid reservoir.
11. Reconnect the washer fluid hose to the nozzle.
12. Slide the nozzle back into its housing.
13. Secure the nozzle in place with the screws that you removed in Step 4.
14. Fill the washer fluid reservoir with washer fluid.
15. Test the headlight washer system by turning on the wipers. The headlight washers should spray water onto the headlights.
If the headlight washer system does not work properly after following these steps, you may need to take your vehicle to a mechanic for further diagnosis and repair.
