1. Jack and jack stands
2. Screwdriver
3. Adjustable wrench
4. Socket wrench set (10mm and 13mm)
5. Brake cleaner
6. New brake pads
7. Brake grease
8. C-clamp
Step-by-Step Guide:
1. Park your Durango on a level surface, engage the parking brake, and turn off the engine.
2. Loosen the lug nuts on the rear wheels, but don't remove them completely.
3. Use a jack and jack stands to raise the rear of the Durango until the rear wheels are off the ground.
4. Remove the lug nuts and take off the rear wheels.
5. Locate the brake caliper on the back of the wheel hub.
6. Use a screwdriver to remove the retaining pins on the caliper.
7. Slide the caliper off the rotor.
8. Inspect the old brake pads for wear or damage and replace them if necessary.
9. Remove any dirt or debris from the caliper and rotor.
10. Apply brake grease to the back of the new brake pads.
11. Slide the new brake pads into the caliper.
12. Reinstall the retaining pins and the brake caliper.
13. Reattach the rear wheels and lug nuts.
14. Tighten the lug nuts in a star pattern.
15. Lower the vehicle using the jack stands.
16. Use the adjustable wrench to turn the brake caliper clockwise until the brake fluid reservoir is full.
17. Pump the brake pedal several times to ensure the brake pads are properly seated.
18. Re-check the brake fluid level in the reservoir and top off if needed.
19. Test the brakes by applying pressure on the brake pedal and ensuring the vehicle stops smoothly.
Remember to follow the owner's manual or repair guide specific to your vehicle for detailed instructions and safety precautions.
