- 8mm socket
- 10mm socket
- 12mm socket
- 14mm socket
- Feeler gauge
- Torque wrench
- Screwdriver
Instructions
1. Open the oil fill cap to allow air to enter the cylinder head.
2. Start the engine and run it at idle.
3. Use the 8mm socket to loosen the locknuts on the valve covers.
4. Remove the valve covers.
5. Use the 10mm socket to loosen the locknuts on the rocker arms.
6. Use the 12mm socket to turn the adjusting screw on the rocker arm until the feeler gauge fits snugly between the valve stem and the rocker arm.
7. Tighten the locknuts on the rocker arms.
8. Replace the valve covers.
9. Tighten the locknuts on the valve covers.
10. Start the engine and check for oil leaks.
