1. Impact wrench
2. 3/8-inch drive socket set
3. Flywheel puller
4. Flywheel holder
5. Screwdriver
6. Hammer
Instructions:
1. Disconnect the battery.
2. Remove the transmission cover.
3. Remove the six bolts that hold the flywheel to the crankshaft.
4. Use an impact wrench to loosen the flywheel nut.
5. Remove the flywheel nut.
6. Use the flywheel puller to pull the flywheel off of the crankshaft.
7. Remove the old gasket from the flywheel.
8. Clean the flywheel and the crankshaft.
9. Apply a new gasket to the flywheel.
10. Install the flywheel on the crankshaft.
11. Tighten the flywheel nut to the specified torque.
12. Install the six bolts that hold the flywheel to the crankshaft.
13. Replace the transmission cover.
14. Connect the battery.
