Ensure the chainsaw is turned off and disconnected from the power source for safety.
Gather your tools and materials, including a new chain drive sprocket, a wrench, and a screwdriver.
Locate the chain drive sprocket on the chainsaw. It is usually situated at the front of the chainsaw, opposite the clutch.
Use the wrench to loosen and remove the nuts holding the chain drive sprocket in place. Be careful not to lose the nuts and washers.
Carefully pry off the old chain drive sprocket using a screwdriver. Be cautious not to damage other components nearby.
Position the new chain drive sprocket onto the shaft. Make sure it is correctly aligned and seated properly.
Secure the new chain drive sprocket in place by replacing the nuts and washers you removed earlier.
Use the wrench to tighten the nuts securely, ensuring the chain drive sprocket is firmly attached.
Reattach the chain to the sprocket, ensuring proper alignment and tension.
Double-check all connections to ensure everything is secure and properly fastened.
You have successfully replaced the chain drive sprocket on your Husqvarna 41 chainsaw. Remember, if you are uncomfortable performing this task, it's best to seek assistance from a qualified technician.
