How do you bypass your MTD Yard Machine riding mower safety switch system due to the deck is removed and it being only used ride around on?

Bypassing the safety switch system on your MTD Yard Machine can be dangerous and is generally not recommended. The safety switch is designed to prevent the mower from starting if the deck is not properly installed or if someone is in the path of the blades. Removing the deck and bypassing the safety switch increases the risk of injury and should only be done if absolutely necessary.

Here are the general steps on how to bypass the safety switch system on an MTD Yard Machine riding mower:

1. Disconnect the battery: Before starting any work, disconnect the battery to ensure the mower cannot be accidentally started.

2. Locate the safety switch: The safety switch is usually located under the seat or on the side of the mower near the deck. It is typically a black or red button that needs to be pressed in order for the mower to start.

3. Bypass the safety switch: There are different ways to bypass the safety switch, depending on the model of your mower. Some common methods include:

- Unplug the safety switch: Locate the wire harness connected to the safety switch and unplug it. This will disconnect the switch from the mower's electrical system.

- Bridge the safety switch wires: Another method involves bridging the wires that connect to the safety switch. To do this, simply twist the ends of the wires together or connect them with a jumper wire.

4. Reconnect the battery: Once the safety switch has been bypassed, reconnect the battery to restore power to the mower.

5. Test the mower: Start the mower and check that the blades engage and operate normally.

It is important to note that bypassing the safety switch should only be done as a temporary measure until you can properly repair or replace the faulty switch. Using the mower without a properly functioning safety switch can be extremely dangerous and could result in serious injuries.