- Jack and jack stands
- Lug wrench
- Socket set
- Brake caliper tool
- Pliers
- Flathead screwdriver
- Brake fluid
Instructions:
1. Prepare the vehicle.
- Park the car on a flat surface and be safe by engaging the parking brake and chocking the front wheels.
- Locate the jack points. Consult the vehicle's owner's manual if needed.
- Lift the rear of the car with a jack and place jack stands under the frame to support it.
2. Remove the wheels.
- Use the lug wrench to loosen and remove the lug nuts.
- Remove the wheels.
3. Remove the brake caliper.
- Locate the brake caliper.
-Use a socket wrench to loosen and remove the bolts holding the caliper to the caliper bracket.
- Remove the caliper bracket.
- Remove the caliper.
- Use pliers or a flathead screwdriver to push back the caliper piston into the caliper housing.
4. Remove the brake pads.
- Remove the old brake pads from the caliper housing.
5. Inspect the brake components.
- Check the brake rotors, calipers, and pads for wear, cracks, or other damage.
- Replace any damaged components.
6. Install the new brake pads.
- Install the new brake pads into the caliper housing.
- Ensure the pads are properly seated and aligned.
7. Reinstall the brake caliper.
- Reinstall the brake caliper bracket.
- Reinstall the caliper and bolt it securely to the caliper bracket.
8. Install the wheels.
- Replace the wheels and lug nuts.
- Tighten the lug nuts in a star pattern to 90 ft-lb.
9. Test the brakes.
- Slowly and carefully drive the car and test the brakes.
- Make sure there are no strange sounds, vibrations, or other issues with the brakes.
Remember: Safety first. Brake work can be dangerous, especially if the vehicle is not properly supported. If you're not comfortable performing this task, take your vehicle to a qualified mechanic.
