- Flat head screwdriver
- Pliers
- Socket set
- Wrench
Instructions:
1. Remove the center console trim
- Use a flat head screwdriver to pry up the center console trim. It is held in place by plastic clips.
- Once the trim is removed, you will see the gear shift lever.
2. Remove the gear knob
- There is a small screw located at the bottom of the gear knob. Use a Phillips head screwdriver to remove this screw.
- Once the screw is removed, you can pull up on the gear knob to remove it.
3. Remove the old gear knob insert
- The gear knob insert is held in place by a C-clip. Use pliers to remove the C-clip.
- Once the C-clip is removed, you can pull out the old gear knob insert.
4. Install the new gear knob insert
- Insert the new gear knob insert into the gear knob.
- Make sure the C-clip is in place to hold the insert in place.
5. Install the new gear knob
- Slide the new gear knob over the gear shift lever.
- Make sure the screw hole is aligned with the hole in the gear shift lever.
- Insert the screw and tighten it to hold the gear knob in place.
6. Replace the center console trim
- Snap the center console trim back into place. Make sure all of the clips are engaged.
Your new Picasso C3 gear knob is now installed!
