- Phillips screwdriver
- Flathead screwdriver
- Replacement brake light bulb (size 7440/ 7443)**
- Gloves
Instructions:
1. Park the car in a safe location and apply the parking brake.
2. Open the trunk and locate the access panel for the brake lights.
3. Use the Phillips screwdriver to turn the screws on the access panel and remove it.
4. Locate the brake light bulb. it will be in a socket and held in place with a retaining clip.
5. Use the flathead screwdriver to gently pry the retaining clip out of the way.
6. Pull the old brake light bulb out of the socket.
7. Insert the new brake light bulb into the socket and make sure it is seated properly.
8. Push the retaining clip back into place.
9. Replace the access panel and secure it with the Phillips screwdriver.
10. Close the trunk, turn on the headlights and test the new brake light bulb.
It is recommended that you replace both brake light bulbs at the same time, even if only one is burned out, to ensure even lighting.
NOTE: If you choose not to replace both bulbs at the same time, the new brake light bulb will appear brighter than the old bulb, which can be distracting to other drivers.
Always dispose of old bulbs safely and in accordance with local regulations.
