Disclaimer: This procedure involves modifying the vehicle's electrical system, and any mistakes can lead to serious consequences. It is recommended that you only perform this procedure if you have experience working on car electrical systems and take all necessary safety precautions.
1. Locate the neutral safety switch. In a Chevy Cavalier, it's usually located near the transmission shifter assembly.
2. Identify the wires connected to the neutral safety switch. There should be three wires:
- Power wire: This wire provides power to the switch.
- Ground wire: This wire connects the switch to the vehicle's ground.
- Output wire: This wire sends a signal to the vehicle's starter solenoid to engage the starter motor when the transmission is in neutral.
3. Disconnect the wires from the neutral safety switch. Use a wrench or pliers to loosen the nuts or screws that hold the wires in place. Be careful not to lose the nuts or screws.
4. Connect the power wire to the ground wire. This will create a circuit that bypasses the neutral safety switch.
5. Test the bypass. Put the transmission in neutral and try to start the vehicle. If the vehicle starts, the bypass has been successful.
Again, it's essential to note that bypassing the neutral safety switch is not a recommended practice and can be dangerous. It is best to have the switch repaired or replaced if it's faulty. Consult a qualified mechanic or refer to your vehicle's repair manual for proper troubleshooting and repair procedures.
