2. Locate the washer fluid reservoir. It is usually a translucent plastic container located in the engine bay.
3. Check the washer fluid level. If it is low, add enough washer fluid to bring the level up to the "Full" mark.
4. Locate the washer fluid level sensor. It is usually located near the bottom of the reservoir.
5. Check the washer fluid level sensor for any obstructions. If there are any obstructions, remove them.
6. Disconnect the electrical connector from the washer fluid level sensor.
7. Remove the washer fluid level sensor from the reservoir.
8. Inspect the washer fluid level sensor for any damage. If the sensor is damaged, replace it.
9. Reinstall the washer fluid level sensor in the reservoir.
10. Reconnect the electrical connector to the washer fluid level sensor.
11. Close the hood of the car.
12. The message in your dash should no longer appear.
