* Phillips head screwdriver
* Flat head screwdriver
* Socket wrench set
* 7mm socket
* 10mm socket
Instructions:
1. Open the driver's door and remove the two Phillips head screws that are located at the bottom of the door panel.
2. Use the flat head screwdriver to pry up the plastic trim cover that is located around the door handle.
3. Remove the two Phillips head screws that are located behind the trim cover.
4. Use the socket wrench and 7mm socket to remove the two bolts that are located at the bottom of the door panel.
5. Use the socket wrench and 10mm socket to remove the two bolts that are located at the top of the door panel.
6. Gently pull the door panel away from the door. It is attached by plastic clips, so be careful not to break them.
7. Disconnect the electrical connectors that are attached to the door panel.
8. Remove the door panel from the door.
To reinstall the door panel, follow these steps in reverse order.
