- Flat-head screwdriver
- Phillips-head screwdriver
- Pliers
- Wrench
Instructions:
1. Locate the driver's side seatbelt buckle. It is located on the floor of the vehicle, near the door.
2. Use the flat-head screwdriver to pry open the plastic cover of the seatbelt buckle.
3. Remove the two Phillips-head screws that hold the seatbelt buckle in place.
4. Disconnect the electrical connector from the seatbelt buckle.
5. Remove the seatbelt buckle from the vehicle.
To install a new seatbelt buckle:
1. Insert the new seatbelt buckle into the vehicle.
2. Connect the electrical connector to the seatbelt buckle.
3. Replace the Phillips-head screws that hold the seatbelt buckle in place.
4. Replace the plastic cover of the seatbelt buckle.
5. Test the seatbelt buckle to make sure it is working properly.
