1. Coil (may be required)
2. Ignition module
3. Distributor cap and rotor
4. Spark plug wires
Additional parts that may be needed for installation include:
* Mounting hardware
* Wiring harness
* Heat sink (if required)
* Shielding or cover (optional)
Tools required:
* Screwdrivers
* Socket set
* Wrenches
* Pliers
* Wire cutters/strippers
* Timing light
Instructions:
1. Disconnect the negative battery terminal to prevent electrical shock during installation.
2. Remove the old ignition points, condenser, and any other associated components from the distributor.
3. Mount the new ignition module to the distributor or firewall (depending on the type of ignition system you are installing).
4. Connect the ignition module to the coil, distributor, and battery using the provided wiring harness.
5. Install the new distributor cap and rotor.
6. Install the new spark plug wires.
7. Reconnect the negative battery terminal.
8. Start the engine and check the timing using a timing light. Adjust the timing if necessary by turning the distributor until the engine is running smoothly and at the correct timing setting.
Note: The specific instructions for installing your electronic ignition system may vary depending on the make and model of your vehicle. Refer to the manufacturer's instructions provided with the ignition system for specific details.
