1. Gather the necessary tools and materials:
- New oil filter (check the owner's manual for the correct size and type)
- Oil filter wrench
- Oil drain pan
- Funnel
- Clean rags or paper towels
2. Prepare your vehicle:
- Park your vehicle on a level surface.
- Engage the parking brake.
- Turn off the engine and allow it to cool.
- Locate the oil filter housing on the underside of your vehicle. In most Honda CR-V models, it is near the bottom of the engine on the driver's side.
3. Place the oil drain pan underneath the oil filter housing:
- Make sure the pan is large enough to catch all the oil that will drain out when you remove the oil filter.
4. Loosen the oil filter:
- Use the oil filter wrench to turn the oil filter counterclockwise until it is loosened. Be careful not to drop the filter into the oil pan.
5. Remove the oil filter:
- Once the oil filter is loosened, unscrew it by hand and remove it from the housing. Be careful, as some oil may drip from the filter.
6. Clean the oil filter housing:
- Wipe the threads of the oil filter housing with a clean rag to remove any dirt or debris.
7. Apply a thin coat of new oil to the gasket of the new oil filter:
- This will help create a seal and prevent leaks.
8. Screw the new oil filter in by hand:
- Do not over-tighten the oil filter. Hand-tighten it until it is snug, then turn it an additional 1/2 to 3/4 of a turn.
9. Add new oil to the engine:
- Use the funnel to add the recommended amount of new oil to the engine. Check the owner's manual for the specific amount required.
10. Start the engine and let it run for a few minutes:
- This will circulate the new oil throughout the engine and filter out any air pockets.
11. Check for leaks:
- Inspect the area around the oil filter housing for any leaks. If you see any leaks, tighten the oil filter until the leak stops.
That's it! You have successfully removed and replaced the oil filter on your Honda CR-V.
