- New valve cover gasket
- Valve cover gasket maker (optional)
- Socket wrench set
- Phillips head screwdriver
- Flathead screwdriver
- Oil drain pan
- Rags
- Safety glasses
Instructions:
1. Park your car on a level surface and allow the engine to cool down.
2. Locate the valve cover. It is located at the top of the engine, and it is usually made of metal or plastic.
3. Remove the valve cover bolts. Use a socket wrench to loosen the bolts that hold the valve cover in place.
4. Remove the old valve cover gasket. Carefully pry the old gasket off of the valve cover and the cylinder head. Be careful not to damage the gasket surfaces.
5. Clean the gasket surfaces. Use a rag and some degreaser to clean the gasket surfaces on the valve cover and the cylinder head.
6. Apply a thin layer of valve cover gasket maker to the gasket surfaces. This will help to seal the gasket and prevent leaks.
7. Install the new valve cover gasket. Carefully position the new gasket on the valve cover and the cylinder head. Make sure that the gasket is seated properly.
8. Reinstall the valve cover bolts. Tighten the bolts until they are snug. Do not overtighten the bolts, as this can damage the valve cover.
9. Start the engine and check for leaks. Run the engine for a few minutes and then check for leaks around the valve cover. If you see any leaks, tighten the valve cover bolts a little bit more.
Tips:
- It may be helpful to have someone assist you with this repair, as it can be difficult to hold the valve cover in place while tightening the bolts.
- Be careful not to drop any bolts or nuts into the engine. If you do, you may have to remove the oil pan to retrieve them.
- If you are not comfortable performing this repair yourself, you can have a qualified mechanic do it for you.
