1. Safety First
- Engage parking brake and loosen lug nuts.
- Raise the vehicle safely with a jack and jack stands.
- Secure the vehicle to ensure stability.
2. Remove Tire and Wheel Assembly
- Remove lug nuts and take off the wheel to expose the brake components.
3. Remove Brake Caliper
- Locate and remove the two bolts that hold the brake caliper in place.
- Unbolt and lift off the caliper, being cautious not to strain or damage the brake line.
- Hang the caliper out of the way using wire or a zip tie.
4. Remove Old Rotor
- Unscrew the two screws holding the rotor to the hub.
- Slide off the old rotor.
5. Clean Hub
- Clean the hub with a wire brush to remove any rust or dirt.
6. Install New Rotor
- Position the new rotor onto the hub.
- Insert the two screws removed earlier and hand-tighten.
- Tighten the screws with a wrench in a star pattern to evenly distribute the force.
7. Reinstall Brake Caliper
- Reposition the brake caliper over the new rotor.
- Install the two bolts that hold the caliper in place. Tighten firmly.
- Reconnect the brake line if it was removed.
8. Reinstall Wheel Assembly
- Put the wheel back onto the hub.
- Install lug nuts and hand-tighten them.
- Lower the vehicle and tighten lug nuts fully with a wrench in a star pattern.
9. Test the Brakes
- Before driving, test the brakes by pressing the brake pedal firmly.
- Ensure the brake pedal feels firm and the vehicle stops smoothly.
Remember, vehicle repair tasks can be complex and safety is paramount. If you're not comfortable performing this task, it's best to seek assistance from a professional.
