Tools Needed
•Socket Set
•Ratchet Extention
1. Use a socket set to loosen the bolts holding the door attached to the frame. This will be located along the door frame.
2. Open the door fully. Remove the bolts that are located along the door inside.
3. There will be two rubber stoppers on the end of the door. Remove the stoppers. There are two 10 mm bolts that are underneath. Remove these bolts.
4. Remove the power cord, if so equipped, behind the kick panel.
5. Disconnect the door lock rod that runs from the door to the body of the car.
6. Remove any electrical wires.
7. Pull the door from the body.
