- Flat-head screwdriver
- Phillips-head screwdriver
- 10mm socket wrench
- Ratchet
- Extension bar
- Socket set
- Rear cup holder
Instructions:
1. Locate the two screws that hold the center console lid in place. They are located on the underside of the lid, near the front edge.
2. Use a flat-head screwdriver to pry up the covers on the screws.
3. Use a Phillips-head screwdriver to remove the screws.
4. Lift up the center console lid to access the underside of the console.
5. Locate the two 10mm bolts that hold the rear cup holder bracket in place. They are located on either side of the bracket, near the front edge.
6. Use a 10mm socket wrench and extension bar to loosen and remove the bolts.
7. Lift the rear cup holder bracket out of the console.
8. Remove the four screws that secure the existing cup holder to the bracket.
9. Use a socket set to remove the four nuts that secure the bracket to the console.
10. Lift the bracket off the console.
11. Install the new rear cup holder bracket to the console.
12. Use a socket set to secure the bracket with the four nuts.
13. Attach the cup holder to the bracket with the four screws.
14. Lower the rear cup holder bracket back into the console.
15. Replace the two 10mm bolts that secure the bracket in place.
16. Tighten the bolts until they are snug.
17. Replace the center console lid.
18. Replace the two screws that hold the lid in place.
19. Test the rear cup holder to make sure it is installed securely.
