- Flathead screwdriver
- Phillips head screwdriver
- 5.25-inch speakers
- Wiring kit (optional)
- Crimp tool (optional)
Instructions:
1. Remove the door panel.
- Use a flathead screwdriver to pry up the plastic cover over the door handle.
- Remove the two Phillips head screws behind the cover.
- Pull the door panel straight up to remove it.
2. Remove the factory speaker.
- Use a Phillips head screwdriver to remove the four screws holding the speaker in place.
- Disconnect the speaker wires.
3. Install the new speaker.
- Connect the speaker wires to the new speaker.
- Use the four screws to secure the new speaker in place.
4. Reinstall the door panel.
- Align the door panel with the door frame and press it straight down until it snaps into place.
- Replace the two Phillips head screws behind the cover.
- Replace the plastic cover over the door handle.
5. Test the speakers.
- Turn on the stereo and make sure the new speakers are working properly.
Tips:
- If your new speakers did not come with speaker wires, you will need to purchase a wiring kit.
- If you are not comfortable crimping your own speaker wires, you can take your car to a local audio shop and have them do it for you.
- Make sure that the new speakers are the same size as the factory speakers.
