Tools and Supplies Needed
* Brake fluid (DOT 3 or DOT 4)
* Brake line wrench
* Clear tubing
* Wrench
* Rags
* Safety glasses
Instructions
1. Park the truck on level ground and turn off the engine.
2. Apply the parking brake.
3. Open the hood and locate the brake fluid reservoir. It is usually located on the driver's side of the engine compartment near the firewall.
4. Remove the cap from the brake fluid reservoir.
5. Attach one end of the clear tubing to the bleeder screw on the front driver's side caliper.
6. Place the other end of the tubing into a clear container that is partially filled with brake fluid.
7. Have a friend slowly press down on the brake pedal while you open the bleeder screw.
8. When you see brake fluid coming out of the tubing, close the bleeder screw.
9. Repeat steps 7 and 8 until no more air bubbles come out of the tubing.
10. Repeat steps 5 through 9 for the front passenger's side caliper.
11. Top up the brake fluid reservoir with brake fluid to the "FULL" line.
12. Replace the cap on the brake fluid reservoir.
13. Test the brakes by applying pressure to the brake pedal. The pedal should feel firm and not spongy.
Safety Precautions
* Wear safety glasses to protect your eyes from brake fluid.
* Do not let brake fluid come into contact with your skin or eyes.
* Brake fluid is flammable, so keep it away from sources of ignition.
* If brake fluid gets on your skin or eyes, flush immediately with water.
* If you swallow brake fluid, contact a poison control center.
* Brake fluid is harmful to the environment, so please dispose of it properly.
