- Use a pry bar or panel remover to pry the plastic fasteners holding the panel in place.
- Be careful not to damage the panel or the paint around it.
2. Locate the window regulator.
- It is located inside the door, behind the glass.
3. Remove the bolts holding the regulator in place.
- There are usually four bolts, two on each side of the regulator.
4. Disconnect the electrical connector from the regulator.
- Be careful not to damage the connector.
5. Remove the regulator from the door.
6. Replace the plastic clips that hold the regulator to the window.
7. Reinstall the regulator in the door.
8. Reconnect the electrical connector to the regulator.
9. Tighten the bolts holding the regulator in place.
10. Reinstall the door panel.
