Auto >> AutoSPT >  >> Auto Repair

How do you remove the inside door panels on a 2008 Subaru Impreza?

To remove the inside door panels on a 2008 Subaru Impreza, follow these steps:

1. Remove the door handle bezel. There are two screws holding the bezel in place. Remove these screws and then pry the bezel off with a plastic pry tool.

2. Remove the window switch panel. There are two screws holding the panel in place. Remove these screws and then pull the panel straight out.

3. Remove the armrest. There are two screws holding the armrest in place. Remove these screws and then pull the armrest straight up.

4. Remove the door pull handle. There is one screw holding the handle in place. Remove this screw and then pull the handle straight up.

5. Remove the remaining screws holding the door panel in place. There are four screws located around the perimeter of the door panel. Remove these screws and then pull the panel straight off.

Be careful not to damage the door panel or any of the components attached to it when removing it.

Auto Repair
How do you replace the alternator on a 1987 Honda Accord LX-I? What is diagnostic code p0551 for chrysler sebring?
Car Care
Will my insurance rates go up if I turn in a claim? Everything You Need to Know About Snow Tires Car wash in Huntington – All you need to know
Engine
How do you decode a Yamaha blaster vin number on the engine? What is the adjustment of valve tappet clearance Mitsubishi 4dr7 diesel engine?
Electric Car
How much should you expect to pay for a rebuilt transmission your 1999 Chevy 3500 4x4 truck? How do hybrids generate electricity? What would make a 1999 ford ranger run lean?
Autopilot
Where is the crank sensor in a 2001 mitsubishe montero sport? Do you need front turn signals on a motorcycle in NY?
Car Photos
Gross vehicle weight of a 1987 chevy blazer K5? Where is the vehicle speed sensor on a 1987 Chevy Blazer? When detailing a car with good paint can you start glaze and then use cleaner wax?