Preparations:
1. Turn the ignition switch to the "ON" position without starting the engine.
2. Press and hold the "ODO/TRIP" button on the instrument cluster.
Resetting the Maintenance Light:
1. While holding the "ODO/TRIP" button, turn the ignition switch to the "OFF" position.
2. Continue to hold the "ODO/TRIP" button for approximately 5-10 seconds until the maintenance light starts blinking.
3. Release the "ODO/TRIP" button.
Confirmation of Reset:
1. The maintenance light will turn off, indicating that the reset was successful.
Additional Tips:
- Make sure to perform regular maintenance on your Sequoia, as recommended in the owner's manual, to avoid any potential issues.
- If the maintenance light comes on again before the next recommended service interval, it's best to have your vehicle checked by a qualified mechanic to determine the cause.
- Please note that the specific steps for resetting the maintenance light may vary slightly depending on the exact trim and model of your 2008 Sequoia. Consult the owner's manual for your specific vehicle model for precise instructions.
