- Lug wrench to loosen the lug nuts
- Jack and jack stands to raise the car and support it securely
- 17mm socket to remove the lug nuts
- Phillips head screwdriver to remove the caliper slide bolts
- Caliper spreader tool to compress the caliper piston
- New brake pads
- Brake grease
Once you have gathered the necessary tools, follow these steps to change the brake pads:
1. Park your car on a level surface and engage the parking brake.
2. Use the lug wrench to loosen the lug nuts on the affected wheels.
3. Raise the car using the jack and place jack stands beneath the pinch welds on the frame to support the car securely.
4. Remove the lug nuts and take off the wheels.
5. Use the Phillips head screwdriver to remove the two caliper slide bolts.
6. Lift the caliper off the rotor and hang it out of the way using a bungee cord or a piece of wire.
7. Use the caliper spreader tool to compress the caliper piston.
8. Insert the new brake pads into the caliper bracket.
9. Install the caliper slide bolts and tighten them until snug.
10. Put the wheels back on and tighten the lug nuts.
11. Lower the car and remove the jack stands.
12. Test the brakes before driving the car.
Remember, brake work can be dangerous if done improperly. If you are not comfortable performing this task, it is best to leave it to a qualified mechanic.
