1. Remove the door handle bezel.
- Use a flat-head screwdriver to pry the bezel away from the door panel.
- Start from the bottom of the bezel and work your way around.
- Be careful not to damage the bezel or the door panel.
2. Remove the four screws that hold the door panel in place.
- Two screws are located at the top of the door panel, one at the front, and one at the rear.
- Two screws are located at the bottom of the door panel, one in the front, and one in the back.
- Use a Phillips-head screwdriver to remove the screws.
3. Disconnect the window switch and door lock switch harnesses.
- The window switch harness is located at the front of the door panel, near the top.
- The door lock switch harness is located at the rear of the door panel, near the top.
- Press on the release tabs and pull the harnesses out of the door panel.
4. Remove the door panel.
- Starting from the bottom of the door panel, pull the panel away from the door.
- The panel will unclip from the door and can be removed.
5. Reinstall the door panel.
- To reinstall the door panel, reverse the steps above.
- Make sure that the window switch and door lock switch harnesses are properly connected.
- Ensure that all four screws are tightened securely.
- Snap the door handle bezel back into place.
Here are some additional tips for removing the door panel on a 1997 GMC 2500:
- If the door panel is difficult to remove, you can use a putty knife or pry bar to help pry it away from the door.
- Be careful not to damage the door panel or the surrounding trim.
- Take your time and be careful, and you should be able to remove the door panel without any problems.
