To access the windshield washer pump, you will need to:
1. Remove the plastic cover under the front fender.
2. Locate the windshield washer pump, which is a small, black cylinder with two hoses attached to it.
3. Disconnect the hoses from the pump.
4. Remove the bolts that hold the pump in place.
5. Pull the pump out of the vehicle.
Installation: To install the new windshield washer pump, simply reverse the steps above.
Here are some additional tips for replacing the windshield washer pump:
* Be sure to disconnect the battery before starting work.
* If the pump is stuck, you may need to use a penetrating oil to loosen it up.
* Be careful not to damage the hoses when you are disconnecting them.
* Make sure that the new pump is properly seated before you tighten the bolts.
Testing the Pump: Once the new pump is installed, you can test it by turning on the windshield wipers. If the pump is working properly, you should see fluid spraying onto the windshield.
