Auto >> AutoSPT >  >> Auto Repair

How do you replace a 2002 Hyundai Elantra cigarette lighter assembly?

Replacing a 2002 Hyundai Elantra cigarette lighter assembly involves the following steps:

1. Safety First: Before you begin any work, ensure that your vehicle is turned off and the engine has cooled down completely. Disconnect the negative terminal of the car battery to avoid electrical hazards.

2. Remove Center Console:

- Locate the screws holding the center console in place. These screws are usually under the dashboard or near the gear shift area.

- Use a screwdriver to remove the screws. Disconnect any electrical connections present under the console.

- Carefully lift and remove the center console from the vehicle.

3. Locate Cigarette Lighter Assembly:

- Once the center console is removed, you will be able to see the cigarette lighter assembly. It is usually located near the front of the console.

- Disconnect any electrical connector attached to the cigarette lighter.

- Remove the screws or clips holding the cigarette lighter assembly in place.

4. Remove Old Assembly:

- Once the screws are removed, gently pull out the old cigarette lighter assembly from its housing. Be careful not to damage any surrounding components.

5. Install New Assembly:

- Take the new cigarette lighter assembly and insert it into the housing where you removed the old one.

- Secure it by replacing the screws or clips.

- Connect the electrical connector that you disconnected earlier.

6. Test Assembly:

- Turn on the car's ignition to test the new cigarette lighter assembly. Insert a lighter or charger to ensure it works correctly.

7. Reinstall Center Console:

- Reinstall the center console by placing it back in its original position and securing it with the screws you removed earlier.

- Reconnect any electrical connections you disconnected during disassembly.

8. Reconnect Battery:

- Once you have finished installing the center console, reconnect the negative terminal of the car battery.

Double-check all connections and ensure that the cigarette lighter assembly is functioning properly before closing everything up. If you encounter any difficulties or uncertainties during this process, you may want to consult a qualified mechanic for assistance.