1. Prepare your tools and materials. You will need a new clutch kit, a flywheel removal tool, a transmission jack, a breaker bar, a ratchet, a socket set, a torque wrench, and safety glasses.
2. Park your car on a level surface and engage the parking brake. Turn off the engine and allow it to cool down.
3. Raise your car with a jack and support it on jack stands. Make sure that the car is stable before you begin working.
4. Locate the transmission inspection cover on the bottom of your car. It is usually held in place by a few bolts.
5. Remove the transmission inspection cover. This will allow you to access the clutch assembly.
6. Use the flywheel removal tool to remove the flywheel from the engine. Be careful not to drop the flywheel.
7. Remove the clutch pressure plate and friction disc from the engine.
8. Inspect the clutch pressure plate and friction disc for wear or damage. If either component is worn or damaged, it must be replaced.
9. Install the new friction disc on the engine. Make sure that the friction disc is properly aligned with the engine flywheel.
10. Install the clutch pressure plate on the engine. Tighten the pressure plate bolts to the specified torque.
11. Install the flywheel on the engine. Tighten the flywheel bolts to the specified torque.
12. Reinstall the transmission inspection cover.
13. Lower your car from the jack stands and remove the jack.
14. Test drive your car to make sure that the clutch is working properly.
